Site Information

 Loading... Please wait...
  • Image 1
  • Image 2
  • Image 3
  • Image 4
  • Image 5

FOA-TTMS-L Light R/C Motorization System, 12V System

6.00 LBS
Calculated at checkout

Product Description

TTMSMotorization System, Light

Non-assembled Motorization Unit for scale vehicles [i.e. 1/6 scale to 1:1 scale]. The minimum height of this system is 2.5" from ground to highest point, but shaft center to back bolt center is 0.75"


This self-standing motorization unit consists of two DC 12V 300 RPM Large Torque Geared Gear Micro Electric Motor in parallel, with reduction gears, chain gears, and sturdy frames to install in any motorized scale vehicle with a minimum internal width of 17.1 cm (6.75").

Drive Shaft: 5/8" Cold-Drawn Steel with 3/16" keyway.

Floor print of unit: 17.1 cm width (6.75") by 23.5 cm length (9.25") - could be reduced to 7.75" if removing the outside back arms. Distance from sprocket shaft center to front of unit: 1.25 cm (0.5"). The back of the motorization unit can be raised or lowered, depending on floor configuration.

The frame has a low front profile, but can be reversed upward.


  • Self Standing: this unit can be installed in vehicle of variable structural stress resistance (i.e. Plastic, Fiberglass, Metal). It is a stand alone unit because of its laser cut frame mixed with steel cross braces.
  • Powerful: The 35W motors, 300 rpm @ 12 VDC.
  • Reliable: A series of flanged bearings on the sprocket keyed shaft provides perfect alignment and decreases rotational friction.
  • Two high Amperage Speed controllers
  • Mixer is necessary if one stick control is used
  • Fuse Box recommended


Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Find Similar Products by Category