Site Information

 Loading... Please wait...
  • Image 1
  • Image 2
  • Image 3
  • Image 4

FOA001RC-HUBE Two Drive Sprockets for RC Panzer IV Early (up to Ausf.G)

5.00 LBS
Calculated at checkout
Current Stock:

Product Description

RC Panzer IV Ausf.D-G - Combat Sprocket



  • Solid 2" Aluminum Hub with 5/8" hole ID, 30mm wide with 7mm lip, 50mm OD with 35mm inner hub
  • One 10-24 Set Screw
  • 3/16" keyway
  • Six 3/16" holes for Sprocket Mounting aligning with bolts on sprocket.
  • Two Resin inner wheels
  • Two 14-gauge outer sprocket teeth ring with 24 screws
  • 6 8-32 Bolts, 1 1/4" L

The drive sprocket is made for the TTMS Motorization System shaft of 5/8" with Keyway. The keyway will allow no scratching of the shaft by the set screw, for easy removal of the sprocket, but also allow full width contact between the shaft and the hub. "RC Combat" tested.

FOA recommands:

  • Install both outer sprocket teeth on the resin sprockets
  • Slide the inner sprocket first into the 5/8" shaft
  • Attach the aluminum hub to the 5/8" shaft, with the set screw, with 'dry-fitting' the sprocket with the tracks/road wheels/return rollers
  • Then slide both resin sprockets in place and secure them with the 6 bolts
  • Finally, glue the cap on

Product Reviews

Write Review

This product hasn't received any reviews yet. Be the first to review this product!

Find Similar Products by Category