FOA001RC-IDLER2 Two Idler for RC Panzer IV Late

• Two identical Resin wheels
• Two bushings 1/2" ID

Masters for the wheels were done in 3D print to achieve a perfect balance with the bushings and the wheels.

The idler wheel is made for the MPSS Suspension System 1/2" shaft. A 3/8" bolt inside an 1/2" sleeve is inserted in the bushing, between aluminum spacers and a washer/bolt to lock it in place. The hub cap goes over it.

FOA recommends:

• Drill through the resin on the back-side of the idler's arms and insert self-tapping screws to make sure the idler does not separate during operation.
• Before gluing/screwing both idler wheels together, insert the bushings and put the 1/2" sleeve through BOTH bushings. It will allow the wheel to be perfectly balanced.